How to Use the Quad Lock 360 Roll Cage Mount Off-Road
By Quad Lock USA® - Official Store | Published: 2026-10-29
Category: How-to Guides
Learn to install and adjust the Quad Lock 360 Roll Cage Mount for secure phone mounting on UTVs, ATVs, and 4x4 vehicles. Step-by-step guide with common mistakes.
Quick answer
Install the Quad Lock 360 Roll Cage Mount by clamping it to a horizontal roll bar, adjusting the dual pivot arm for your ideal viewing angle, and locking your phone into the patented dual-stage lever head.
Why the Roll Cage Mount Works Off-Road
Unlike adhesive or suction mounts that can fail on bumpy trails, the Quad Lock 360 Roll Cage Mount uses a mechanical clamp that wraps around a roll bar, side-by-side cage, or truck tube. The dual pivot arm lets you tilt and rotate your phone to avoid glare or reach, while the lever head keeps the device locked even during hard hits.
The mount works best on round or slightly oval bars between 1.5 and 2.5 inches in diameter. If your vehicle has a non-standard bar shape or a padded roll cage, you may need an adapter or alternative mounting point.
Step-by-step installation guide
- Choose a mounting location: Select a horizontal roll bar section within easy reach of the driver or passenger. The clamp needs at least 2 inches of unobstructed bar length. Avoid areas where the arm might hit your head or the steering wheel. Test the position by sitting in the seat before tightening.
- Attach the clamp to the roll bar: Open the clamp fully, place it around the bar, and hand-tighten the knob until the rubber pads grip the bar evenly. Do not overtighten — the rubber pads provide enough friction without damaging the bar's paint or coating. If the mount slips after tightening, the bar may be too narrow or too wide; check the diameter range.
- Adjust the dual pivot arm: Loosen both pivot knobs, position the arm so the phone sits at your preferred viewing angle, then retighten. The arm can be angled left/right and tilted up/down. A common mistake is leaving the arm too loose — the phone will wobble on rough terrain. Tighten the knobs firmly by hand; do not use tools as they can strip the plastic.
- Mount your phone in the lever head: Place your Quad Lock case or adapter onto the head, then push the lever down until it clicks. Give the phone a gentle tug to confirm it is locked. The lever must be fully closed — a half-closed lever can release on big bumps. Always double-check the lever before driving; a quick visual check takes one second.
Product details
- Quad Lock 360 - Roll Cage Mount: The Quad Lock 360 Roll Cage Mount includes the Quad Lock 360 Base, Arm and Head, designed for mounting on roll bars of side-by-sides, UTVs, ATVs, and off-road vehicles. You get a complete mounting system in one box, so you don't need to buy separate parts for a secure off-road phone mount.
Quad Lock 360 - Roll Cage Mount
