Truck Kits for iPhone: Adhesive Dash Mount Setup Guide
By Quad Lock USA® - Official Store | Published: 2026-10-31
Category: How-to Guides
Set up a Quad Lock Adhesive Dash/Console Mount for your iPhone in a truck. Prep the surface, choose a flat or slightly curved spot, and avoid common mistakes.
Quick answer
Use the Quad Lock Adhesive Dash/Console Mount with a Quad Lock Case or Universal Adaptor. Clean and dry a flat or slightly curved dash surface, test-fit the mount, then press the 3M VHB base firmly and let it bond before attaching your iPhone.
Why surface choice decides whether the mount stays put
The Adhesive Dash/Console Mount uses 3M VHB adhesive and a flexible base, so it can adhere to flat and slightly curved surfaces. That flexibility helps on a gently contoured console, but it does not turn a deeply textured or sharply angled panel into a good bonding surface.
Pick a spot that is smooth, clean and out of direct sun if possible. A shaded area keeps the adhesive from softening during long parking sessions, and a flat or only slightly curved face gives the base the best chance to stay seated.
When the adhesive mount is the wrong choice
If your truck has a heavily textured dash, a soft-touch pad or a steeply curved console, the adhesive base may not bond reliably. In that case, a mechanical mount that clamps or clips to a vent or other hard point is a better fit.
The Adhesive Dash/Console Mount is a single-head option, so it is best for drivers who want a low-profile, semi-permanent spot rather than a mount they move between vehicles every day.
Adhesive dash mount setup steps
- Clean the mounting surface: Wipe the chosen flat or slightly curved area with a lint-free cloth and a mild cleaner, then let it dry completely. Common mistake: skipping this step leaves dust or oils that weaken the 3M VHB bond. The surface must be dry and free of residue before you peel any backing.
- Test-fit the mount and head angle: Hold the mount in place without removing the adhesive liner and check that the adjustable pivot head points toward you and does not block controls or vents. Common mistake: bonding first and discovering the angle is wrong. Adjust the pivot head before the base is stuck down.
- Apply the adhesive base: Peel the liner and press the flexible base firmly onto the surface for at least 30 seconds, working from the center outward. Common mistake: pressing only the edges, which leaves air pockets under the center. Firm, even pressure across the whole base matters more than a quick press.
- Let the bond cure before mounting your iPhone: Wait before attaching your phone, especially in cold weather, so the adhesive can reach full strength. Common mistake: clipping the phone on immediately and letting its weight pull on a fresh bond. A short cure time protects the bond from day one.
- Attach your iPhone and set the viewing angle: Twist your Quad Lock Case or Universal Adaptor onto the head until it locks, then adjust the pivot head so the screen is readable without blocking your view. Common mistake: forcing the case if it does not seat, which usually means the adaptor is misaligned. The case should lock with a firm twist, not a push.
Product facts
- Truck - Adhesive Dash/Console Mount: The Adhesive Dash/Console Mount uses 3M VHB adhesive with a flexible base for flat and slightly curved surfaces. This means you can mount it on a gently contoured dash or console, but you should avoid deep curves or textured pads where the base cannot sit flush.
Truck - Adhesive Dash/Console Mount - Truck - Adhesive Dash/Console Mount: It is compatible with all Quad Lock Cases and Universal Adaptors and has an adjustable pivot head. You can reuse the mount if you change phones, as long as you use a compatible case or adaptor, and tilt the head to a comfortable viewing angle.
